Repair it yourself
Incl. risk of a failed attempt: €25–€39
Pros and cons
- + Usually the cheapest option
- + Device stays with you, no data loss from shipping
- − Risk of further damage
- − Tools needed, water resistance may be lost
Analogue stick moves by itself
Repair makes economic senseData quality: high
Nintendo Switch (OLED-Modell), Fix stick drift: doing it yourself costs about €15–€23 for spare parts, at an independent shop about €49–€79. New it costs about €328–€330. The possible saving compared with buying new is therefore €305–€315.
Data as of:
| Verdict | Repair makes economic sense (Data quality: high) |
|---|---|
| Independent repair shop | €49–€79 |
| Repair it yourself (parts) | €15–€23 |
| Buy used (same model) | €185–€273 |
| Buy new | €328–€330 – Nintendo Switch (OLED-Modell) new |
| Saving vs. buying new | €305–€315 |
| Data as of | 12/11/2026 |
All prices on this page come from Germany (euros) – we don't have prices for your country yet. Enter quotes from your country in the calculator below.
You save compared with buying new
€305–€315
All prices used come from named sources.
Incl. risk of a failed attempt: €25–€39
Nintendo Switch (OLED-Modell) new
Advantages of buying new
Adjust age, condition and prices – for example with a real quote from a repair shop.
You save compared with buying new
€305–€315
All prices used come from named sources.
| Option | Cost | Use | Per year |
|---|---|---|---|
| Repair it yourself | €25–€39 | 4 yrs | €6–€10 |
| Have it repaired | €49–€79 | 4 yrs | €12–€20 |
| Buy used | €185–€273 | 4.6 yrs | €40–€59 |
| Buy new | €328–€330 | 7 yrs | €47 |
We only show parts for exactly this model. Real retailer prices appear once a retailer interface is connected; until then the links lead to the retailer's search.
Original or third-party – check with the seller
€15–€23Sourced
Tools: Y00 tri-wing screwdriver, Phillips PH000, Tweezers, Spudger
General procedure, not yet reviewed by an expert for the Nintendo Switch (OLED-Modell). Screw positions and cable order are in the model-specific guide (links below).
Analogue stick drift is caused by wear in the stick module. Before replacing it, try calibrating in the system settings.
Run the stick calibration in the system settings. If that helps permanently, no replacement is needed.
Loosen the screws with the right tool (Y00 tri-wing for Joy-Cons). Open the housing carefully.
There's a small lithium battery in the controller – don't bend or pierce it.
Lift the battery carefully and remove the cover plate to reach the stick module.
Open the ribbon cable latch, unscrew the old module, insert the new one and slide the cable back in.
Close the housing, calibrate and test the stick.
Nintendo Switch (OLED-Modell), Fix stick drift: Doing it yourself costs about €15–€23 for the spare part, an independent shop charges about €49–€79. As of: 12/11/2026.
Repair makes economic sense. The cheapest repair costs about €15–€23, a new device about €185–€273. That saves you about €305–€315 compared with buying new. All prices used come from named sources.
Yes. Difficulty: medium, time needed about 30 minutes to 1 hours. You need: Y00 tri-wing screwdriver, Phillips PH000, Tweezers, Spudger. There's a small lithium battery in the controller – detach it carefully, don't bend it.
Analogue stick module for Nintendo Switch (OLED-Modell): about €15–€23. Before buying, check that the part is listed for exactly your model.
Working devices are currently offered for about €185–€273. A broken device fetches much less – factor that into your decision.
At independent repair shops near you or at the manufacturer. Our repair-shop finder searches by postcode – sorted only by distance, without paid placements.